[chirp_users] Program cable with CHIRP software

[Colton Meyer]

I have gotten the same message with other BTECH radios and have 
proceeded without problems.

Colton Meyer  WD6CWM, WRDD814

On 10/20/2019 6:48 PM, Augliera Jim via chirp_users wrote:
> I purchased the BTECH- Baofeng Tech.com programming cable, #PC03 FTDI 
> Cable Dual Pin, UPC # 7 0174807090409; along with the new BF-F8HP and 
> UV-5R radios.
>
> When I attach the programming cable to the radio and connect the USB 
> end of the programming cable to USB port on the computer; I receive a 
> warning message, telling me this radio's driver is experimental, and 
> asking if I want to proceed? I do have the CHIRP software installed on 
> this computer.
>
> I have attached an image of the warning message. I am not sure if I 
> should proceed or not.
>
> Can you offer some guidance with this?
>
> Thank you,
>
>
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to Colton Meyer at cwmeyer at hughes.net
> To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20191021/9c1a57e2/attachment.html