[chirp_users] Program cable with CHIRP software

[John LaMartina]

As Colton mentioned, that’s the standard CHIRP disclaimer. 

John

Www.Miklor.com 

> On Oct 21, 2019, at 12:05 PM, Colton Meyer <cwmeyer at hughes.net> wrote:
> 
> 
> I have gotten the same message with other BTECH radios and have proceeded without problems.  
> 
> Colton Meyer  WD6CWM, WRDD814
> 
> On 10/20/2019 6:48 PM, Augliera Jim via chirp_users wrote:
>> I purchased the BTECH- Baofeng Tech.com programming cable, #PC03 FTDI Cable Dual Pin, UPC # 7 0174807090409; along with the new BF-F8HP and UV-5R radios.
>> 
>> When I attach the programming cable to the radio and connect the USB end of the programming cable to USB port on the computer; I receive a warning message, telling me this radio's driver is experimental, and asking if I want to proceed? I do have the CHIRP software installed on this computer.
>> 
>> I have attached an image of the warning message. I am not sure if I should proceed or not.
>> 
>> Can you offer some guidance with this?
>> 
>> Thank you,
>> 
>> 
>> 
>> _______________________________________________
>> chirp_users mailing list
>> chirp_users at intrepid.danplanet.com
>> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>> This message was sent to Colton Meyer at cwmeyer at hughes.net
>> To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to John LaMartina at johnla at usa.net
> To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20191021/325f375f/attachment.html