[chirp_users] problem with baofeng uv-5r

[Amnon Zohar]

Tx jim ill check with external mic. Any suggestion to solve it?

בתאריך יום ב׳, 12 בנוב' 2018, 16:36, מאת Jim Unroe <rock.unroe at gmail.com>:

> On Mon, Nov 12, 2018 at 8:55 AM Amnon Zohar <amnon.zohar at gmail.com> wrote:
> >
> > not exactly a chirp issue:
> >
> > i have few uv-5r's
> >
> > one of them can only receive
> > while transmitting the others receive only the bip but not the voice~
> > what might be the reason besides a defective mic
>
> When a external device (speaker/mic, programming cable, etc.) is
> plugged into the socket of the radio, 2 contacts are lifted to
> disconnect the internal microphone and the internal speaker. It is
> common in these radios for the contact to not fully return to the
> initial position when the 2-pin plug is removed. When this happens,
> the internal mic and/or speaker remains disconnected.
>
> >
> > (while checking i found out i cannot manualy change menu 5 from wide to
> narrow . it remais as programmed - this IS a chirp issue(
>
> This is not a CHIRP issue. This is how the radio works. You cannot
> permanently change any parameter of a programmed memory. You can only
> temporarily change TX power output level by tapping the [#] or swap
> the TX and RX frequencies by tapping the [*] to put the radio into
> "reverse" mode.
>
> You can only manually update the TX frequency and either the TX DCS
> code or TX CTCSS tone by entering the values in the top (A) VFO and
> then write the new values to the appropriate memory using menu 28
> (MEM-CH). To change any other parameter, including menu 5 (W/N), you
> must erase the memory and program the memory back from scratch using
> the top (A) VFO or use programming software such as CHIRP.
>
> >
> > --
> > Amnon
>
> Jim KC9HI
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to amnon at amnon.zohar at gmail.com
> To unsubscribe, send an email to
> chirp_users-unsubscribe at intrepid.danplanet.com
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20181112/e43f4de7/attachment.html