<div dir="auto">Tx jim ill check with external mic. Any suggestion to solve it?</div><br><div class="gmail_quote"><div dir="ltr">בתאריך יום ב׳, 12 בנוב' 2018, 16:36, מאת Jim Unroe <<a href="mailto:rock.unroe@gmail.com">rock.unroe@gmail.com</a>>:<br></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">On Mon, Nov 12, 2018 at 8:55 AM Amnon Zohar <<a href="mailto:amnon.zohar@gmail.com" target="_blank" rel="noreferrer">amnon.zohar@gmail.com</a>> wrote:<br>
><br>
> not exactly a chirp issue:<br>
><br>
> i have few uv-5r's<br>
><br>
> one of them can only receive<br>
> while transmitting the others receive only the bip but not the voice~<br>
> what might be the reason besides a defective mic<br>
<br>
When a external device (speaker/mic, programming cable, etc.) is<br>
plugged into the socket of the radio, 2 contacts are lifted to<br>
disconnect the internal microphone and the internal speaker. It is<br>
common in these radios for the contact to not fully return to the<br>
initial position when the 2-pin plug is removed. When this happens,<br>
the internal mic and/or speaker remains disconnected.<br>
<br>
><br>
> (while checking i found out i cannot manualy change menu 5 from wide to narrow . it remais as programmed - this IS a chirp issue(<br>
<br>
This is not a CHIRP issue. This is how the radio works. You cannot<br>
permanently change any parameter of a programmed memory. You can only<br>
temporarily change TX power output level by tapping the [#] or swap<br>
the TX and RX frequencies by tapping the [*] to put the radio into<br>
"reverse" mode.<br>
<br>
You can only manually update the TX frequency and either the TX DCS<br>
code or TX CTCSS tone by entering the values in the top (A) VFO and<br>
then write the new values to the appropriate memory using menu 28<br>
(MEM-CH). To change any other parameter, including menu 5 (W/N), you<br>
must erase the memory and program the memory back from scratch using<br>
the top (A) VFO or use programming software such as CHIRP.<br>
<br>
><br>
> --<br>
> Amnon<br>
<br>
Jim KC9HI<br>
_______________________________________________<br>
chirp_users mailing list<br>
<a href="mailto:chirp_users@intrepid.danplanet.com" target="_blank" rel="noreferrer">chirp_users@intrepid.danplanet.com</a><br>
<a href="http://intrepid.danplanet.com/mailman/listinfo/chirp_users" rel="noreferrer noreferrer" target="_blank">http://intrepid.danplanet.com/mailman/listinfo/chirp_users</a><br>
This message was sent to amnon at <a href="mailto:amnon.zohar@gmail.com" target="_blank" rel="noreferrer">amnon.zohar@gmail.com</a><br>
To unsubscribe, send an email to <a href="mailto:chirp_users-unsubscribe@intrepid.danplanet.com" target="_blank" rel="noreferrer">chirp_users-unsubscribe@intrepid.danplanet.com</a><br>
</blockquote></div>