[chirp_users] Issue with programming Baofeng UV-82HP

[Jardy Dawson]

Instead of TSQL, just use Tone.

Jardy Dawson
WA7JRD Ham Radio

Message sent by... Oh who the heck really cares?

On Apr 22, 2018, at 23:32, Ernst Wittenschläger <ernst.wittenschlaeger at gmail.com> wrote:

Hi All,
I am using CHIRP to program in all of my repeaters into the UV-82HP. I ran into an issue: When loading in the CTCSS Codes to "unlock" the repeater, the software will load the CTCSS code on BOTH the Receive CTCSS (R-CTCS, Menu 11) and Transmit CTCSS (T-CTCS, Menu 13), instead of ONLY the T-CTCS, so I am unable to receive any signal coming back from the repeaters. Afterwards, when I try to change the R-CTCS to 0.000 Hz, it will automatically switch back to the programmed R-CTCS code when I exit the Menu. I have not seen in CHIRP a way to program EITHER the R-CTCS or the T-CTCS, there's only one called:TSQL, which seemingly changes both the R-CTCS & the T-CTCS

Is there a way where I can change my R-CTCS codes back to 0.000 Hz and save the setting permanently in my radio?

Thanks & 73!
Ernst
WA3FAW
_______________________________________________
chirp_users mailing list
chirp_users at intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to Jardy at jardy72 at yahoo.com
To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com