[chirp_users] Wouxun KG-UV8D Won't Open Squelch

[Jeff]

Or None on the Tone Mode if you're not using any.

On April 2, 2018 4:16:44 PM UTC, Jeff <wireless3.14159 at gmail.com> wrote:
>If  Cross Mode is other than Tone->Tone this could happen. And Tone
>Mode should be set to Tone of course.
>
>On April 2, 2018 4:05:26 PM UTC, Joe Hobart <nova at npgcable.com> wrote:
>>Chirp appears to program the KG-UV8D (Chirp reports software version
>>UV8DV1.05),
>>but received signals will not open the squelch.  I have to manually go
>>to every
>>channel in the radio and change either R-CTC or R-DCS before there is
>>audio (the
>>monitor button also works).  Three of these radios behave the same.  I
>>have no
>>other versions of Wouxan img files.
>>
>>Once I fiddle with the R-CTC or R-DCS settings the radios receive
>>normally, but
>>changing 100 channels in each of 3 radios would be tedious.
>>
>>Known history: These radios were purchased new, used for local
>>communications,
>>and retired with broken antennas.
>>
>>
>>Chirp procedure using a recently updated Linux Mint version:
>>
>>There are no values visible in the Chirp spreadsheet for CTS or DCS.
>>
>>Download img file from Wouxan
>>Delete old frequencies
>>Add about 100 frequencies (copied from UV-5R file)
>>Upload to same Wouxan
>>
>>What might I be doing wrong, and what can I do to correct this
>problem?
>>
>>Thanks,
>>Joe, W7LUX
>>_______________________________________________
>>chirp_users mailing list
>>chirp_users at intrepid.danplanet.com
>>http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>>This message was sent to Jeff at wireless3.14159 at gmail.com
>>To unsubscribe, send an email to
>>chirp_users-unsubscribe at intrepid.danplanet.com