[chirp_users] Freq entry

[John LaMartina ☀]

Gary,
When you update a Channel manually, you need to delete the prior channel data, menu 28. Then program the new channel data and save with menu 27.

You cannot simply override any existing channel.

John 'Miklor'
Http://www.miklor.com 

> On Nov 5, 2015, at 12:13 PM, Gary Runningbear <runningbear2000 at gmail.com> wrote:
> 
> Just found another problem. I enter a frequency a ct tone and an offset and save to a channel. This is in the VFO of Courts. then I go to channel mode and pull up that channel and find that the CT tone and the offset have not carried over. It is acting like a simplex frequency. did I do something wrong or miss something?
> 
>> On Nov 5, 2015 11:28 AM, "Gary Runningbear" <runningbear2000 at gmail.com> wrote:
>> Ok. I just figured out how to add up to 5 decimal places. many thanks
>> 
>>> On Nov 5, 2015 11:23 AM, "Jim Unroe" <rock.unroe at gmail.com> wrote:
>>> On Thu, Nov 5, 2015 at 11:02 AM, Gary Runningbear
>>> <runningbear2000 at gmail.com> wrote:
>>> > In the UV 82L, when adding frequencies that have four to five digits to the
>>> > right of the decimal point how do you get  the last one or two digits in
>>> > there?
>>> >
>>> 
>>> You just type it into the Frequency cell of the memory spreadsheet editor.
>>> 
>>> If you are talking about entering the frequency into the VFO using the
>>> keypad (which has nothing to do with CHIRP), you do the following:
>>> 
>>> 1 set menu 1 (STEP) to a value that is compatible with the frequency
>>> that you want to enter
>>> 2 key in the 1st 6 digits of the frequency
>>> 3 press the [^] up arrow key once
>>> 
>>> For example if you want to listen to FRS channel, 462.5625 MHz
>>> 
>>> 1 Set STEP to 2.5KHZ, 6.25KHZ or 12.5KHZ
>>> 2 Key in 462562 (after entering the last 2, the frequency will be
>>> rounded off to the 1st STEP compatible frequency below the desired
>>> frequency)
>>> 3 Press the [^] up arrow key once (the display will read "462.562"
>>> followed by a very small 5)
>>> 
>>> Jim KC9HI
>>> _______________________________________________
>>> chirp_users mailing list
>>> chirp_users at intrepid.danplanet.com
>>> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>>> To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20151105/65befaf5/attachment.html