[chirp_users] Freq entry

[David Buss]

Oops, forgot to say, it should work properly, just not show it. 

D. Buss
KD9EBR

-----Original Message-----
From: Gary Runningbear <runningbear2000 at gmail.com>
To: Discussion of CHIRP <chirp_users at intrepid.danplanet.com>
Sent: Thu, 05 Nov 2015 11:14
Subject: Re: [chirp_users] Freq entry

Just found another problem. I enter a frequency a ct tone and an offset and
save to a channel. This is in the VFO of Courts. then I go to channel mode
and pull up that channel and find that the CT tone and the offset have not
carried over. It is acting like a simplex frequency. did I do something
wrong or miss something?
On Nov 5, 2015 11:28 AM, "Gary Runningbear" <runningbear2000 at gmail.com>
wrote:

> Ok. I just figured out how to add up to 5 decimal places. many thanks
> On Nov 5, 2015 11:23 AM, "Jim Unroe" <rock.unroe at gmail.com> wrote:
>
>> On Thu, Nov 5, 2015 at 11:02 AM, Gary Runningbear
>> <runningbear2000 at gmail.com> wrote:
>> > In the UV 82L, when adding frequencies that have four to five digits to
>> the
>> > right of the decimal point how do you get  the last one or two digits in
>> > there?
>> >
>>
>> You just type it into the Frequency cell of the memory spreadsheet editor.
>>
>> If you are talking about entering the frequency into the VFO using the
>> keypad (which has nothing to do with CHIRP), you do the following:
>>
>> 1 set menu 1 (STEP) to a value that is compatible with the frequency
>> that you want to enter
>> 2 key in the 1st 6 digits of the frequency
>> 3 press the [^] up arrow key once
>>
>> For example if you want to listen to FRS channel, 462.5625 MHz
>>
>> 1 Set STEP to 2.5KHZ, 6.25KHZ or 12.5KHZ
>> 2 Key in 462562 (after entering the last 2, the frequency will be
>> rounded off to the 1st STEP compatible frequency below the desired
>> frequency)
>> 3 Press the [^] up arrow key once (the display will read "462.562"
>> followed by a very small 5)
>>
>> Jim KC9HI
>> _______________________________________________
>> chirp_users mailing list
>> chirp_users at intrepid.danplanet.com
>> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>> To unsubscribe, send an email to
>> chirp_users-unsubscribe at intrepid.danplanet.com
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20151105/2cb29045/attachment.html