[chirp_users] Baofeng BF-F8HP

[Rick Osgood]

I have the cable branded Baofeng. I uninstalled the new version and
installed v3.2.0.0. Following directions, I unplugged the usb cable, ran
the install then plugged the cable back in. Windows did not even see that a
new device has been introduced. I had to shave off a little of the
connector that plugs into the radio or it would only go in half way. I am
sure it is seated fully now....

Help!

On Fri, Jan 23, 2015 at 8:59 AM, Jim Unroe <rock.unroe at gmail.com> wrote:

> On Fri, Jan 23, 2015 at 8:18 AM, Rick Osgood <rposgood at gmail.com> wrote:
> > Is this model supported by Chirp or can I select a different model?
> Windows
> > 7 finally saw the usb connection and it is now listed as an unknown
> device?
> >
> > Thanks for the great work!
> >
> > --
> > Rick Osgood
>
> >From the Supported Radios list on the CHIRP home page...
>
> Baofeng/Pofung
> BF-F8HP (in daily builds)
>
>
> If you have a programming cable with a Prolific type chip, be sure to
> downgrade your installed driver to v3.2.0.0.
>
> http://www.miklor.com/COM/UV_Drivers.php
>
> Jim KC9HI
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>



-- 
Rick Osgood
411 Walnut Street #9722
Green Cove Springs, FL 34023
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20150123/2b63cb5b/attachment.html