[chirp_users] Dstar ID-RP4000V Repeater

[Michael Walker]

You may need the drivers for the Icom USB interfaces from the Icom install
disk.  They are somewhat unique.

Mike va3mw


On Sat, Nov 8, 2014 at 11:35 PM, Robert Keeton <rkeeton at blarg.net> wrote:

> I have an ICOM , ID-RP4000V Dstar repeater.  According to the Wiki page
> both the VHF and UHF repeater is supported.  When I check the daily build
> list it is not shown as supported and I could not locate a *.py file for
> the repeater.  I have been through the archives and found reference that
> support for the ID-RP400V was added and it was working , but not much other
> info.  When I run Chirp to try detect the repeater/radio I get an error
> message “ An error has occurred Unable to get radio model”.  I have tried
> both the most up to date windows version and a USB thumb drive with the
> Live CD loaded.  Both versions operate fine , but with the error message.
> Any suggestions????
>
> Bob K7MHJ
>
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20141109/17602c49/attachment.html