[chirp_users] Baofeng uv-5r plus not able to read from

[Milton Hywatt]

If you visit here: http://www.miklor.com/uv5r/
I think you will get your problems sorted out in
short order. Looks like by the driver device your
using a linux OS. There are a few considerations 
but I think they are covered on the Miklor site. 


________________________________
 From: Tony Cratz <cratz at hematite.com>
To: chirp_users at intrepid.danplanet.com 
Sent: Wednesday, October 9, 2013 11:13 PM
Subject: [chirp_users] Baofeng uv-5r plus not able to read from
 

Hello,

    I just purchase a UV-5R+ and was trying to program it. I'm using
    the chirp-daily respository version.

    USB Cable: : Prolific Technology Inc. pl2303 3-2:1.0: pl2303
    device: /dev/ttyUSB0
    UV-5R+ Firmware: BFB297 (as reported via power-on)

    I get the typical unable to connect to radio, but when it is
    trying to clone I see on the HT the "Welcome...." message and
    then I get the timeout message.

    As for the cable, it does seem to be full seated. I have
    pressed and held the plug in to make sure and get the same
    results.

    First is there a debug mode I can turn on to capture the hand
    shake between the computer and the UV-5R+. I figure this would
    help the list.


                            Tony
_______________________________________________
chirp_users mailing list
chirp_users at intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20131009/5e23ef1d/attachment.html