[chirp_users] Baofeng uv-5r plus not able to read from

[Tony Cratz]

Hello,

	I just purchase a UV-5R+ and was trying to program it. I'm using
	the chirp-daily respository version.

	USB Cable: : Prolific Technology Inc. pl2303 3-2:1.0: pl2303
	device: /dev/ttyUSB0
	UV-5R+ Firmware: BFB297 (as reported via power-on)

	I get the typical unable to connect to radio, but when it is
	trying to clone I see on the HT the "Welcome...." message and
	then I get the timeout message.

	As for the cable, it does seem to be full seated. I have
	pressed and held the plug in to make sure and get the same
	results.

	First is there a debug mode I can turn on to capture the hand
	shake between the computer and the UV-5R+. I figure this would
	help the list.


							Tony