[chirp_users] Programming Baofeng GT3 - Mk11

[Ken Vernon]

Thanks Jim, I have programmed a gt3tp that has the same case.. I don’t believe that is the issue.

Sent from my iPhone

> On 21 Nov 2020, at 12:01, Jim Unroe <rock.unroe at gmail.com> wrote:
> 
> Hi Ken,
> 
>> On Fri, Nov 20, 2020 at 7:56 PM Ken Vernon <kennethjv at bigpond.com> wrote:
>> 
>> Hey Jim, thanks very much for your speedy reply. As suggested I’ve tried uv5r but receive a message advising’an error has occurred - radio did not respond’. Cheers Ken
>> 
>> Sent from my iPhone
>> 
>>>> On 21 Nov 2020, at 11:43, Jim Unroe <rock.unroe at gmail.com> wrote:
>>> 
>>> Hi Ken,
> 
> This is most likely due to the 2-pin plug not being fully inserted in
> the socket. The case design of the GT-3 series radios has a ridge that
> runs around the socket well. The plastic shell contacts this ridge
> before the pins are fully inserted. A workaround for this is to trim
> some plastic off of the shell to reduce/eliminate the interference.
> 
> See this page (scroll down to GT-3) for more information.
> https://www.miklor.com/COM/UV_ErrorMess.php#error1
> 
> Jim KC9HI
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to Ken at kennethjv at bigpond.com
> To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com