[chirp_users] Chirp under Linux

[Nigel A. Gunn G8IFF/W8IFF]

Have you added yourself to the 'dialout' group?
If not, try 
sudo adduser <username> dialout


> On 07 December 2019 at 19:47 Phil <phillor9 at gmail.com> wrote:
> 
> 
> Thank you for reading this.
> 
> I bought a Baofeng UV-82HP about four months ago and I cannot get Chirp 
> to read from the radio, or in fact to do anything with the radio.
> 
> I'm running Chirp under Kubuntu and have tried every Chip daily version 
> over the past four months. This is the error message that I receive when 
> I attempt to read from the radio:
> 
> "Radio did not respond"
> 
> These are the entered parameters:
> 
> /dev/ttyUSB0
> Baofeng
> UV-82HP
> 
> I have read and write access to the serial port which is the same port 
> that I use for several application including programming an Arduino 
> board. I have tried several different Baofeng models, just in case, with 
> the same result.
> 
> I've trimmed the plastic from the plug so that it slips into the radio's 
> sockets more easily. I've attempted to read from the radio in both 
> channel and frequency modes. Finally, I've searched the Internet for 
> even the slightest clue but to no avail.
> 
> I do not know anyone who owns a Baofeng radio or who uses Chirp. So this 
> mailing list is my last hope.
> 
> Any clues at all will greatly appreciated.
> 
> -- 
> Regards,
> Phil
> 
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to Nigel Gunn, W8IFF at nigel at ngunn.net
> To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com

Nigel A. Gunn, ///shoulders.outwards.resolutions   tel +1 937 825 5032
Amateur Radio G8IFF W8IFF and GMRS WRBV701, e-mail nigel at ngunn.net www http://www.ngunn.net