[chirp_users] Chirp under Linux

[Glenn N0YJV :)]

Phil,
Seeing how you have not gotten this to work on any Baofengs, I would start 
considering the cable, like the chip is bad or it has a short in it.
Can you check the cable?
Or, borrow one from someone to eliminate that possibility, or perhaps spend 
a few bucks and buy another?
HTH.
Glenn
----- Original Message ----- 
From: "Phil" <phillor9 at gmail.com>
To: <chirp_users at intrepid.danplanet.com>
Sent: Saturday, December 07, 2019 6:47 PM
Subject: [chirp_users] Chirp under Linux


> Thank you for reading this.
>
> I bought a Baofeng UV-82HP about four months ago and I cannot get Chirp
> to read from the radio, or in fact to do anything with the radio.
>
> I'm running Chirp under Kubuntu and have tried every Chip daily version
> over the past four months. This is the error message that I receive when
> I attempt to read from the radio:
>
> "Radio did not respond"
>
> These are the entered parameters:
>
> /dev/ttyUSB0
> Baofeng
> UV-82HP
>
> I have read and write access to the serial port which is the same port
> that I use for several application including programming an Arduino
> board. I have tried several different Baofeng models, just in case, with
> the same result.
>
> I've trimmed the plastic from the plug so that it slips into the radio's
> sockets more easily. I've attempted to read from the radio in both
> channel and frequency modes. Finally, I've searched the Internet for
> even the slightest clue but to no avail.
>
> I do not know anyone who owns a Baofeng radio or who uses Chirp. So this
> mailing list is my last hope.
>
> Any clues at all will greatly appreciated.
>
> -- 
> Regards,
> Phil
>
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to Glenn at glennervin at cableone.net
> To unsubscribe, send an email to 
> chirp_users-unsubscribe at intrepid.danplanet.com