[chirp_users] Wrong Kenwood radio, ID or unknown variant, see LOG output.

[Gene Vincent]

That would be wonderful if it is possible.
Thanks.

On Fri, May 11, 2018 at 3:24 PM, Jim Unroe <rock.unroe at gmail.com> wrote:

> On Fri, May 11, 2018 at 10:16 AM, Pavel Milanes Costa <pavelmc at gmail.com>
> wrote:
> > Hi Gene,
> >
> > Kenwood TK-372G Driver author here.
> >
>
> Pavel,
>
> I took a look at the debug log this morning but didn't have time to
> reply (and was hoping that you would also notice this discussion).
>
> It appeared to me that the radio was being read OK. The problem, as I
> saw it, was that CHIRP was receiving "P3720\x06\xfb" from the radio
> but CHIP is expecting "P3720\x06\xff" (the last byte being FB instead
> of FF).
>
> It seems to me that a test driver could be posted that just changes
> the FF to FB to see if the radio could be fully read by CHIRP. If it
> can, then maybe all that is needed would be to add and additional
> "fingerprint" to the driver.
>
> Jim KC9HI
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to gene8348 at gmail.com at gene8348 at gmail.com
> To unsubscribe, send an email to chirp_users-unsubscribe@
> intrepid.danplanet.com
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20180513/ce93cafe/attachment.html