[chirp_users] Reply to MMcabe

[Nigel A. Gunn G8IFF/W8IFF]

The FT-60 seems to a bit picky over the cable it will work with.


> On 15 January 2018 at 18:57 Peter Ryan via chirp_users <chirp_users at intrepid.danplanet.com> wrote:
> 
>     @mmcabe: I am new also. I ran into the same type problems you are, using a Valley Enterprises cable, a Yaesu FT-60, and a Macbook. I solved it by reloading all 3 software apps again...Chirp, Python and PL2303...those being the software apps needed for my Macbook. Fearing a repeat need for this requirement, I have left my computer running since the software re-installs. But give this approach a try. It did work for me. And make SURE you execute the correct steps in the exact CORRECT ORDER vis-a-vis the computer/radio or you will get the same "errors" displayed that are bothering you now.. Good luck.
> 


 

> _______________________________________________
>     chirp_users mailing list
>     chirp_users at intrepid.danplanet.com
>     http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>     This message was sent to Nigel Gunn, W8IFF at nigel at ngunn.net
>     To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com
> 


 


Nigel A. Gunn, 1865 El Camino Drive, Xenia, OH 45385-1115, USA. tel +1 937 825 5032
Amateur Radio G8IFF W8IFF (was KC8NHF 9H3GN), e-mail nigel at ngunn.net www http://www.ngunn.net
Member of ARRL, QRPARCI #11644, SOC #548, Flying Pigs QRP Club International #385,
Dayton ARA #2128, AMSAT-NA LM-1691, GCARES, EAA382.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20180115/cc3b35b6/attachment.html