[chirp_users] Yaesu FT-7900 change memory content display

[Nigel A. Gunn G8IFF/W8IFF]

Try the 'settings' tab in Chirp.

> 
>     On 10 September 2017 at 15:15 Jerome Whelan <whelanjh at gmail.com> wrote:
> 
>     I have successfully programmed several hundred memory channels on my Yaesu FT-7900 using CHIRP.
> 
>     Each memory channel is displayed as “memory address and LABEL".
> 
>     I want each memory channel to display as “memory address and FREQUENCY" instead.
> 
>     Is it possible to select / control this behavior through CHIRP ?
> 
>     Do I need to edit my file to clear all labels and re-upload?
> 
>     Thanks for anyone’s experience here.
> 
>     Jerry AB3SX
> 
>     _______________________________________________
>     chirp_users mailing list
>     chirp_users at intrepid.danplanet.com
>     http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>     This message was sent to Nigel Gunn, W8IFF at nigel at ngunn.net
>     To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com
> 


Nigel A. Gunn, 1865 El Camino Drive, Xenia, OH 45385-1115, USA. tel +1 937 825 5032
Amateur Radio G8IFF W8IFF (was KC8NHF 9H3GN), e-mail nigel at ngunn.net www http://www.ngunn.net
Member of ARRL, QRPARCI #11644, SOC #548, Flying Pigs QRP Club International #385,
Dayton ARA #2128, AMSAT-NA LM-1691, GCARES, EAA382.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20170910/275eb884/attachment.html