[chirp_users] programming issues

[Glenn Wise]

10-9-2017
Follow up on QTY-7900D programming.
Obtained correct USB cable. Problem solved. 
Can read/write both type xcvrs.
Thanks for help. Glenn Wb4zjb

-----Original Message-----
From: chirp_users-bounces at intrepid.danplanet.com [mailto:chirp_users-bounces at intrepid.danplanet.com] On Behalf Of Glenn Wise
Sent: Wednesday, September 20, 2017 7:32 AM
To: 'Discussion of CHIRP'
Subject: Re: [chirp_users] programming issues

9-20-19
Jim, Thanks.  I knew there must be something I was  missing.  
Will obtain correct cable and respond back.
73'3  Glenn Wb4zjb

-----Original Message-----
From: chirp_users-bounces at intrepid.danplanet.com [mailto:chirp_users-bounces at intrepid.danplanet.com] On Behalf Of Jim Unroe
Sent: Wednesday, September 20, 2017 5:31 AM
To: Discussion of CHIRP
Subject: Re: [chirp_users] programming issues

On Tue, Sep 19, 2017 at 11:04 PM, Glenn Wise <ruerue at windstream.net> wrote:
 9-19-2017
 I am using Chirp and a TYT USB cable to program a TYT-9000D 2 meter  ham radio.

 Software and USB cable work without any issues.
 I have tried MULTIPLE times to use same version of CHIRP and same USB  cable to program a QTY-7900D and a QTY-8900D.

 I have NOT ever been able to read the QYT radio’s.  Neither model.
 The software will appear to start to read the radio and then drop out.
 Screen shows either comm. Error or says radio would not go into clone mode.

 By the software and cable working on the TYT-9000D, in my mind that  clears the software and cable.

 IF there were any issues with the software or the cable, I don’t  believe I could use the combo on the TYT-9000D.
 I am open to any suggestions as what to do. HELP Glenn Wb4zjb Glenn, The QYT radios require a different programming cable. 
The TYT uses only the ring (TXD/RXD) and sleeve (GND) connections where the QYT radios use the tip (TXD), ring (RXD) and sleeve (GND) connections.
Jim KC9HI


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus

_______________________________________________
chirp_users mailing list
chirp_users at intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to Glenn at ruerue at windstream.net To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com