[chirp_users] Can't upload to FT-60R

[Chris Fosnight]

Awesome! I haven't used other software, but I really enjoy CHIRP and use it
for all my radios.

Be cautious using CDs that come with inexpensive, cloned-chip cables. I've
seen many that contain viruses. I'd run an antivirus scan to be sure. The
http://www.miklor.com/ website is probably a safer bet.

73

Chris, KG7QCP

On Wed, May 3, 2017 at 8:33 AM, John Perry <wx5jp at jpunix.net> wrote:

> On 5/3/2017 9:50 AM, Chris Fosnight wrote:
> > Your cable seems to be a Prolific clone. Check out the following website
> > with loads of information on that. You basically need to revert to an
> > older version of the driver.
> >
> > http://www.miklor.com/COM/UV_Drivers.php
> >
> > Did I understand the alternate instructions (starting TX, then RX after
> > it errors) worked for you using CHIRP?
> >
> > Chris, KG7QCP
>
> It works! Yay!! Here are the steps I followed:
>
> 1. I have the CD that came with the cable. So that's a plus!
> 2. I disconnected from the Internet completely so it wouldn't go looking
> for the Windows update version of the driver.
> 3. I un-installed the driver from the PC so it would liik for the driver
> again.
> 4. Plugged in the cable and told it I had the CD.
> 5. Voila!! CHIRP now works!!
>
> --
> John Perry - WX5JP
>
>
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to Chris Fosnight at chris.fosnight at gmail.com
> To unsubscribe, send an email to chirp_users-unsubscribe@
> intrepid.danplanet.com
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20170503/a3aa043a/attachment.html