[chirp_users] Baorfeng transmit block while on reverse frequency

[Eric H]

Yes, I have the duplex set to off on almost all of the channels. If I go to one I can talk on, it will allow the R to be displayed. Then if I switch to a channel that duplex is set to off, it still will show the R and transmit. 

Sent from my iPhone

> On Aug 15, 2017, at 5:20 PM, David Dixon <yattonbristol at btinternet.com> wrote:
> 
> Hello 
> 
> Have you set the Duplex to off  try  this  you got nothing to lose
> I  can’t TX even when I  press the scan key ( star key ) for reverse  repeater 
> 
> Just a thought 
> 
> Regards David 
> 
> 
> 
>> On 15 Aug 2017, at 21:43, Eric H <camopainter at hotmail.com> wrote:
>> 
>> I program a lot of Boafeng uv-5r radios and have found an issue. I have a few channels I'd like to talk on and others I do not. If the reverse frequency function is turned on when on a channel you can transmit on, it will allow you to transmit on any channel in the radio. Is there a way to stop this from happening?  You cannot access the reverse frequency option unless on a channel you can transmit on. 
>> 
>> Sent from my iPhone
>> _______________________________________________
>> chirp_users mailing list
>> chirp_users at intrepid.danplanet.com
>> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>> This message was sent to David  at yattonbristol at btinternet.com
>> To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com
> 
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to ERIC at camopainter at hotmail.com
> To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com