[chirp_users] kenwood/baofeng programming

Jim McIver
Mon Apr 3 15:33:43 PDT 2017


Excellent. Thanks again.
-jm

On 4/3/2017 3:32 PM, Jim Unroe wrote:
> Jim,
>
> That looks better.
>
> Are you doing the math to come up with the offset and shift direction?
> If yes, here is a tip that might speed things up for you.
>
> Since you are getting the TX frequency directly from the Kenwood
> software, you can enter that frequency directly into CHIRP. Just set
> Duplex = "split" and enter the TX frequency into the Offset column.
> The you can click the [Refresh] button and CHIRP will to the math and
> set the Duplex and Offset values for you.
>
> Also you can set common setting for multiple memories at the same
> time. For example if you forgot so switch several memories to NFM, you
> can click, shift-click, ctrl-click as needed to highlight a few memory
> rows. Then click the [Properties] button. Then tick the box to the
> left of Mode and then set it to NFM and click OK. All highlighted
> memories will be switched at the same time.
>
> Jim
>
> On Mon, Apr 3, 2017 at 6:14 PM, Jim McIver <jmciver at lmtribune.com> wrote:
>> Thanks all. Does the attached look better?
>> -jm
>>
>> On 4/3/2017 3:04 PM, Jim Unroe wrote:
>>>
>>> On Mon, Apr 3, 2017 at 5:44 PM, Jim McIver <jmciver at lmtribune.com> wrote:
>>>>
>>>> Trying to attach a jpg that shows the kenwood tk-2170 on top and baofeng
>>>> 82c
>>>> on the bottom.
>>>>
>>>> Does it look like I'm programming the baofeng correctly to match the
>>>> kenwood?
>>>>
>>>> thx,
>>>> -jm
>>>
>>>
>>> Jim,
>>>
>>> Not the same. The Kenwood has a TX CTCSS tone programmed but not an RX
>>> CTCSS tone. You are programming both a TX and RX CTCSS tone on the
>>> UV-82C.
>>>
>>> To be the same you must change Tone Mode to Tone and put the CTCSS
>>> tone in the Tone column.
>>>
>>> Jim
>>> _______________________________________________
>>> chirp_users mailing list
>>> chirp_users at intrepid.danplanet.com
>>> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>>> This message was sent to Jim M at jmciver at lmtribune.com
>>> To unsubscribe, send an email to
>>> chirp_users-unsubscribe at intrepid.danplanet.com
>>>
>>
>>
>> _______________________________________________
>> chirp_users mailing list
>> chirp_users at intrepid.danplanet.com
>> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>> This message was sent to Jim at rock.unroe at gmail.com
>> To unsubscribe, send an email to
>> chirp_users-unsubscribe at intrepid.danplanet.com
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to Jim M at jmciver at lmtribune.com
> To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com
>




More information about the chirp_users mailing list