[chirp_users] kenwood/baofeng programming

[Brian]

you do not use TSQL that tells the radio to use both the encode and the 
decode tones.  The Kenwood is only using the Encode tone.  On chirp 
change you mode to tone and remove the tonesql value.  That should work.


Brian Erickson
------------------
"I must not fear.
Fear is the mind-killer.
Fear is the little-death that brings total obliteration.
I will face my fear.
I will permit it to pass over me and through me.
And when it has gone past I will turn the inner eye to see its path.
Where the fear has gone there will be nothing. Only I will remain."



------ Original Message ------
From: "Jim McIver" <jmciver at lmtribune.com>
To: "Chirp" <chirp_users at intrepid.danplanet.com>
Sent: 4/3/2017 3:44:15 PM
Subject: [chirp_users] kenwood/baofeng programming

>Trying to attach a jpg that shows the kenwood tk-2170 on top and 
>baofeng 82c on the bottom.
>
>Does it look like I'm programming the baofeng correctly to match the 
>kenwood?
>
>thx,
>-jm

---
This email has been checked for viruses by AVG.
http://www.avg.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20170403/cea91c30/attachment.html