[chirp_users] Fwd: baofeng 82c

[Jim McIver]

I've been putting kenwood QT/DQT enc in the chirp ToneSql, and where kenwood TX 
and RX are the same, I still put kenwood QT/DQT enc in ToneSql, but don't know if Tone should be TSQL, None, or Tone. 

From: "Chirp" <chirp_users at intrepid.danplanet.com> 
To: "Chirp" <chirp_users at intrepid.danplanet.com> 
Sent: Sunday, April 2, 2017 2:55:07 PM 
Subject: Re: [chirp_users] Fwd: baofeng 82c 

I don't know about that much about Kenwood but these should be correct... 
Kenwood = Chirp 
QT encode = Tone 
QT decode = ToneSql 
DQT encode = DTCS Code 
DQT decode = RX DTCS Code 

For full explanation of Chirp tone mode menus see... 
http://chirp.danplanet.com/projects/chirp/wiki/MemoryEditorColumns 

It may not be of any help but here is a cross reference between Baofeng 
and Chirp menus... 
https://wiki.radioreference.com/index.php/Baofeng_UV-5R#UV-5R_and_UV-82_Menus_vs_CHIRP_Settings 

Tom ND5Y 

On 04/02/2017 04:37 PM, Jim McIver wrote: 
> Purchased a baofeng uv-82c as a backup for my kenwood tk-2170. Chirp 
> won't read the tk-2170 so I am trying to match columns from kenwood 
> program to chirp and don't know what goes where. Where can I get help to 
> make the baofeng work? 
> 
> Attached is what I'm up against. Yes, I've read through all I can find 
> about the baofeng, but lack the knowledge to know all the terminology. 
> Is there a cross reference from kenwood columns to chirp columns? 
> 
> I think I have rows 0 through 6 correct, but now sure about 7 through 
> 10. That's as far as I've gotten. The rest of the rows came from 
> someone's not in my area. 
> 
> Q? how can I leave a blank line in the chirp? 
> 
> Q? Does kenwood QT/DQT Enc go into Chirp ToneSql? 
> 
> Q? How do I know if TSQL is correct Tone Mode in Chirp or should I be 
> using something else in this column? 
> 
> Q? Where do I put the 203.5 from kenwood QT/DQT Dec & QT/DQT Enc in Chirp? 
_______________________________________________ 
chirp_users mailing list 
chirp_users at intrepid.danplanet.com 
http://intrepid.danplanet.com/mailman/listinfo/chirp_users 
This message was sent to Jim M at jmciver at lmtribune.com 
To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20170402/e0141962/attachment.html