[chirp_users] Yaesu Ft-8800

[Amnon Zohar]

you did not have to use your hunch
if you read miklor carefuly the 2 posibilities mentioned by jim are talked
about there

2016-03-05 15:50 GMT+02:00 Jim Unroe <rock.unroe at gmail.com>:

> On Sat, Mar 5, 2016 at 12:55 AM, Lee Houde <houdatto at gmail.com> wrote:
> > I built a cloning cable from scratch today - but it didn't work. I had
> the
> > red wire soldered to the TX pin and the white wire soldered to the RX
> pin as
> > the Miklor instructions stated. On a hunch, I reversed the RX/TX wires
> and
> > now it WORKS! The board had the RX and TX markings reversed. BTW my board
> > has LED lights on it so while I am downloading/uploading I get a little
> > light show!
> >
>
> Unfortunately the labeling on the boards is not consistent.
>
> On some boards...
>
> TX means "TX". Connect it to RX on the other end.
> RX means "RX" Connect it to TX on the other end.
>
> On other boards...
>
> TX means "to TX". Connect it to TX on the other end.
> RX means "to RX". Connect it to RX on the other end.
>
> Jim KC9HI
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to amnon at amnon.zohar at gmail.com
> To unsubscribe, send an email to
> chirp_users-unsubscribe at intrepid.danplanet.com
>



-- 
Amnon
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20160305/dc1f471c/attachment.html