<div dir="rtl"><div dir="ltr">you did not have to use your hunch </div><div dir="ltr">if you read miklor carefuly the 2 posibilities mentioned by jim are talked about there</div></div><div class="gmail_extra"><br><div class="gmail_quote"><div dir="ltr">2016-03-05 15:50 GMT+02:00 Jim Unroe <span dir="ltr"><<a href="mailto:rock.unroe@gmail.com" target="_blank">rock.unroe@gmail.com</a>></span>:</div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">On Sat, Mar 5, 2016 at 12:55 AM, Lee Houde <<a href="mailto:houdatto@gmail.com">houdatto@gmail.com</a>> wrote:<br>
> I built a cloning cable from scratch today - but it didn't work. I had the<br>
> red wire soldered to the TX pin and the white wire soldered to the RX pin as<br>
> the Miklor instructions stated. On a hunch, I reversed the RX/TX wires and<br>
> now it WORKS! The board had the RX and TX markings reversed. BTW my board<br>
> has LED lights on it so while I am downloading/uploading I get a little<br>
> light show!<br>
><br>
<br>
Unfortunately the labeling on the boards is not consistent.<br>
<br>
On some boards...<br>
<br>
TX means "TX". Connect it to RX on the other end.<br>
RX means "RX" Connect it to TX on the other end.<br>
<br>
On other boards...<br>
<br>
TX means "to TX". Connect it to TX on the other end.<br>
RX means "to RX". Connect it to RX on the other end.<br>
<br>
Jim KC9HI<br>
_______________________________________________<br>
chirp_users mailing list<br>
<a href="mailto:chirp_users@intrepid.danplanet.com">chirp_users@intrepid.danplanet.com</a><br>
<a href="http://intrepid.danplanet.com/mailman/listinfo/chirp_users" rel="noreferrer" target="_blank">http://intrepid.danplanet.com/mailman/listinfo/chirp_users</a><br>
This message was sent to amnon at <a href="mailto:amnon.zohar@gmail.com">amnon.zohar@gmail.com</a><br>
To unsubscribe, send an email to <a href="mailto:chirp_users-unsubscribe@intrepid.danplanet.com">chirp_users-unsubscribe@intrepid.danplanet.com</a><br>
</blockquote></div><br><br clear="all"><div><br></div>-- <br><div class="gmail_signature">Amnon</div>
</div>