[chirp_users] Unable to read UV-2501

[John Bryant]

OK. Could you elaborate a bit on that timing/sequence of cable connecting?

Thanks


On 8/26/2016 12:16 PM, Brent Wells wrote:
> John, I have the UV-5001 and I love it. BUT....it's tricky to program, I think. I just had to re-program it the other day to add/remove some channels...took me 45 minutes. I had to download a driver off the FTDI site like the recommended cable directions said, but it's funny the timing of when I have to plug the cable into my laptop, and then plug into my radio.
>
> Brent (N4BDW)
> Sent from my iPhone
>
>> On Aug 26, 2016, at 11:41 AM, john bryant <parrotdise13 at att.net> wrote:
>>
>> Just got a new Btech UV-2501 and unable to read from radio. Error
>> message "radio did not enter clone mode". Then the radio restarts?
>> Anticipating a request for logging files,  I downloaded the
>> manufacturer's programming software and installed. Whenever I try to
>> read from radio, the radio repeatedly cycles on and off until I shut
>> down the software.
>> Any thoughts?
>> Thanks,
>> John, N5SU
>> _______________________________________________
>> chirp_users mailing list
>> chirp_users at intrepid.danplanet.com
>> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>> This message was sent to Brent at n4bdw73 at gmail.com
>> To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to john at parrotdise13 at att.net
> To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com
>