[chirp_users] Not working with new Baofeng UV-5X3

[Douglas Haviland]

Let me know about the chirp fix with that new radio from Baofeng. I just ordered one

Sent from Doug Haviland's iPhone.          (spelling errors likely)

> On Aug 23, 2016, at 7:45 PM, "chirp at ish.net" <chirp at ish.net> wrote:
> 
> My new Baofeng UV-5X3 tri-band HT -- https://baofengtech.com/uv-5x3 --
> just arrived and CHIRP does not even communicate with it. I have a fair
> amount of experience with other Baofeng models and the software, and I
> confirmed that exactly the same configuration and cabling is still
> working with my UV-5R.
> 
> I have the 20160819 release of CHIRP. I tried using the UV-5X setting
> first, and then after than didn't work tried a number of other settings
> including UV-5R, BF-F8HP, and so on. The "Clone progress" dialogue is
> shown but the progress bar remains unmoved, an error dialogue pops up
> that reads "An error has occurred" and "Radio did not respond", followed
> by a delay before the radio lights up its LED green and then red.
> 
> This is on Windows 10 and I could try on Ubuntu 16.04 if requested, but
> as I said this is a working system for other radios.
> 
> -- Mike
> 
> 
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to Doug at doughav at hotmail.com
> To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com