[chirp_users] Freq entry

[Gary Runningbear]

Ok. I just figured out how to add up to 5 decimal places. many thanks
On Nov 5, 2015 11:23 AM, "Jim Unroe" <rock.unroe at gmail.com> wrote:

> On Thu, Nov 5, 2015 at 11:02 AM, Gary Runningbear
> <runningbear2000 at gmail.com> wrote:
> > In the UV 82L, when adding frequencies that have four to five digits to
> the
> > right of the decimal point how do you get  the last one or two digits in
> > there?
> >
>
> You just type it into the Frequency cell of the memory spreadsheet editor.
>
> If you are talking about entering the frequency into the VFO using the
> keypad (which has nothing to do with CHIRP), you do the following:
>
> 1 set menu 1 (STEP) to a value that is compatible with the frequency
> that you want to enter
> 2 key in the 1st 6 digits of the frequency
> 3 press the [^] up arrow key once
>
> For example if you want to listen to FRS channel, 462.5625 MHz
>
> 1 Set STEP to 2.5KHZ, 6.25KHZ or 12.5KHZ
> 2 Key in 462562 (after entering the last 2, the frequency will be
> rounded off to the 1st STEP compatible frequency below the desired
> frequency)
> 3 Press the [^] up arrow key once (the display will read "462.562"
> followed by a very small 5)
>
> Jim KC9HI
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> To unsubscribe, send an email to
> chirp_users-unsubscribe at intrepid.danplanet.com
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20151105/68b02711/attachment.html