[chirp_users] Dumb 8900 queary

Alvin Koffman
Mon Jun 6 12:49:02 PDT 2011

On Mon, Jun 6, 2011 at 2:05 PM, Dan Smith <dsmith at danplanet.com> wrote:

> > 1 how do you tell what port to use?
> I think you said you were using Linux.  If you're using a USB serial
> adapter, then you want /dev/ttyUSB0 (assuming you only have one
> attached).  If you're using the first real serial port, then you'll want
> /dev/ttyS0.
> Ok it's not showing an extra usb so I'll try ttyS0

> > 2 How do you set up the radio? I tried turning the rig on while holding
> > down on the left V/M as the book says, but nothing on rig shows
> "cloning".
> You do get the special multi-tone beep and then get dropped into the
> alternate set menu, right?  The cloning mode is the last one in the
> list, if I recall correctly.  That means a single turn to the left will
> get you there.  Then you have to press another button to actually reboot
> into the cloning menu and then yet another to put it into RX or TX mode.
> OK is the alternate set when you hold the V/m down while turning it on?

> --
> Dan Smith
> www.danplanet.com
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20110606/71538e25/attachment.html 

More information about the chirp_users mailing list