- Am not able to get the D-Rats & DPRS interface working "together".<div>- D-Rats works OK on its own with gps signals/coordinates...as does the DPRS program. But there is no interface between them...meaning D-Rats is not sending the data to the DPRS interface to then be sent out to <a href="http://aprs.fi/">http://aprs.fi/</a>, or elsewhere.</div>
<div>- My setup is a mobile D-Star radio receiving GPS-A RF signals directly from a D-Star HT (not through D-rats with a laptop). The static coordinates put in D-Rats show up on the D-Rats map (w9dbe-1) as do the RF signals from the HT (w9dbe-9).</div>
<div>- DPRS is set up with w9dbe-1 coordinates and is gating them to <a href="http://aprs.fi/">http://aprs.fi/</a>. But is apparently not receiving or sending the D-Rats data out. Have followed the D-Rats instructions for interfacing and do not believe I have made any errors. Note that although the instructions say to input net:<a href="http://127.0.0.1:14550">127.0.0.1:14550</a> into the "Serial" connection section, doing so automatically creates a "Network" entry and not Serial.</div>
<div>- When this new Network entry (named DPRS interface) is not enabled, D-Rats starts up and the Event Log and DeBug look normal (to me at least). But after enabling the new Network entry (net:<a href="http://127.0.0.1:14550">127.0.0.1:14550</a>) the Event Log shows an error of: <i>Failed to connect (Unable to connect ((10061, 'Connection refused')))</i>.</div>
<div>- I have set this entry to have Sniff and Raw Text enabled with 38400 speed.</div><div>- Attached is the Debug Log which also shows the above mentioned "unable to connect" error. Thanks.</div><div>Brent w9dbe</div>
<div><br></div><div><br></div><div><br></div>