<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<HTML><HEAD>
<META HTTP-EQUIV="Content-Type" CONTENT="text/html; charset=us-ascii">
<TITLE>Message</TITLE>
<META content="MSHTML 6.00.6000.16705" name=GENERATOR></HEAD>
<BODY>
<DIV><SPAN class=218362115-01102008><FONT face=Arial size=2><STRONG>After some
trial and error I have found that I get a much better success rate if I set the
"force delay between transmissions" to 1or 2 seconds for repeaters and 3-4 for
reflectors. This ultimately will extend the transfer time but helps insure a
better success rate by allowing for any repeater bounce or unlinking from
reflectors. There are probably different amounts of latency for different
repeaters and reflectors so you may have to play with this a
bit. </STRONG></FONT></SPAN></DIV>
<DIV><SPAN class=218362115-01102008><STRONG><FONT face=Arial
size=2></FONT></STRONG></SPAN> </DIV>
<DIV><SPAN class=218362115-01102008><STRONG><FONT face=Arial size=2>Also could
someone shed more light on the Pipeline Blocks, Warm Up Length and
Warm Up Timeout settings?</FONT></STRONG></SPAN></DIV>
<DIV><SPAN class=218362115-01102008><STRONG><FONT face=Arial
size=2></FONT></STRONG></SPAN> </DIV>
<DIV><SPAN class=218362115-01102008><STRONG><FONT face=Arial
size=2>Thanks</FONT></STRONG></SPAN></DIV>
<DIV><SPAN class=218362115-01102008><STRONG><FONT face=Arial
size=2></FONT></STRONG></SPAN> </DIV>
<DIV><STRONG><FONT face=Arial size=2></FONT></STRONG> </DIV>
<DIV align=left><FONT face="Monotype Corsiva" size=5>Dave Cooley</FONT></DIV>
<DIV align=left><FONT face=Arial size=2><SPAN
class=218362115-01102008>WA4DOC</SPAN></FONT></DIV>
<DIV><SPAN class=218362115-01102008><FONT face=Arial
size=2>EL87UV</FONT></SPAN></DIV></BODY></HTML>