<!doctype html>
<html>
<head>
<meta charset="UTF-8">
</head>
<body>
Thanks for the suggestion, I cleaned the prongs with alcohol I'll clean the base and try again.
<br>
<blockquote type="cite">
On August 22, 2020 at 3:50 PM Jim Unroe <
<a href="mailto:rock.unroe@gmail.com">rock.unroe@gmail.com</a>> wrote:
<br>
<br>
<br>On Sat, Aug 22, 2020 at 6:46 PM Charles Gierke <
<a href="mailto:cgierke@cox.net">cgierke@cox.net</a>> wrote:
<br>>
<blockquote type="cite">
On Wednesday my 2 BaoFeng UV 5R radios could download and upload to CHIRP.
</blockquote>
<blockquote type="cite">
On Friday all I got was the following message: Radio Did Not Respond.
</blockquote>
<blockquote type="cite">
I tried reloading the latest version of CHIRP, no change. I tried an earlier version of CHIRP, no change. I reloaded the latest version back, no change. Visually the radio's red light blinks then the LED display blinks then the error message shows up on CHIRP.
</blockquote>>
<blockquote type="cite">
Any suggestions?
</blockquote>
<blockquote type="cite">
Thanks Chuck KJ7INT
</blockquote>
<br>Hi Chuck,
<br>
<br>You will get the exact same error message if you don't plug the 2-pin
<br>plug into the radio. So make sure that the 2-pin plug is fully
<br>inserted into the socket of the radio. Some have had to put a little
<br>pressure on the plug during the cloning process.
<br>
<br>Jim KC9HI
<br>_______________________________________________
<br>chirp_users mailing list
<br>
<a href="mailto:chirp_users@intrepid.danplanet.com">chirp_users@intrepid.danplanet.com</a>
<br>
<a href="http://intrepid.danplanet.com/mailman/listinfo/chirp_users" rel="noopener" target="_blank">http://intrepid.danplanet.com/mailman/listinfo/chirp_users</a>
<br>This message was sent to Chuck at
<a href="mailto:cgierke@cox.net">cgierke@cox.net</a>
<br>To unsubscribe, send an email to
<a href="mailto:chirp_users-unsubscribe@intrepid.danplanet.com">chirp_users-unsubscribe@intrepid.danplanet.com</a>
</blockquote>
</body>
</html>