<div dir="ltr"><div>Hello chirp  folk</div><div>My first time  using chirpw - not yet totally working yet.</div><div>The mission was to program a Baofeg Radio</div><div>----------------------------------------------------------<br></div><div>Platform is Linux (Mint - Ubuntu based)</div><div>chirpw does install OK in /usr/bin</div><div>It also runs from $HOME/bin if I put a copy there.</div><div><br></div><div>I check with &quot;lsusb&quot; to see that the USB device is seen OK, and all is well.</div><div>1. Firstly, I get a permissions refusal on attempting the communication.</div><div>&quot;An error has occurred</div><div>[Errno 13] could not open port /dev/ttyS0&quot;</div><div><br></div><div>2. If I run chirpw from a terminal, I get message:</div><div>(process:5560): Gtk-WARNING **: 10:09:24.416: Locale not supported by C library.<br>    Using the fallback &#39;C&#39; locale.<br>Gtk-Message: 10:09:24.418: Failed to load module &quot;atk-bridge&quot;</div><div><br></div><div>I check to see libatk-bridge2.0-0 is present - and all is well</div><div>Also libatk-bridge2.0-dev is there</div><div>I do not understand why the module is not loaded.</div><div>The messages seem to come from a process that is named like a LAN network address which keeps changing except for the first number &quot;10&quot;.</div><div>It might some GTK process<br></div><div>--------------------------------------------------------------</div><div>Have I done something catastrophic?</div><div>Maybe missed out something essential?</div><div>Thanks if you can help</div><div>My regards all<br></div><div><br></div><div><br></div></div>