<p dir="ltr">My complaint</p>
<p dir="ltr">Regarding Firmware. If you refuse to provide Firmware to CHIRP programmers I will stop supporting your business & stop using your radios. I have sent you a lot of sales because of CHIRP & how easy it is to use. I love your radios & CHIRP. Together they are great! Honestly your software sucks! It is very difficult to use. I will not try it again. I suggest you supply CHIRP with the UV-5RV2+ & any future firmware or I will boycott your products & send new radio interests elsewhere.</p>
<div class="gmail_quote">On Jun 8, 2016 3:10 PM, "Jim Unroe" <<a href="mailto:rock.unroe@gmail.com">rock.unroe@gmail.com</a>> wrote:<br type="attribution"><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">On Wed, Jun 8, 2016 at 4:51 PM, Steve London <<a href="mailto:n2icarrl@gmail.com">n2icarrl@gmail.com</a>> wrote:<br>
> Success !<br>
><br>
> It ended up being three issues:<br>
><br>
> 1) The speaker and mic jacks on my new UV-5RV2+ are not centered. They<br>
> are off by a few mm. Therefore, my programming cable would not seat<br>
> correctly. Trimmed the cable plug with a utility knife until it seated<br>
> properly. Incidentally, my old UV-5RA has the jacks centered.<br>
><br>
> 2) While trimming the cable plug, I accidentally cut the ground wire.<br>
> After repairing that, the old UV-5RA could be read with CHIRP.<br>
><br>
> 3) The 2014 version of CHIRP does not talk to the new UV-5RV2+. The<br>
> latest build does work correctly with the UV-5RV2+. Thanks !<br>
><br>
> A learning experience.<br>
><br>
> 73,<br>
> Steve, N2IC<br>
<br>
I'm glad to see you have it worked out.<br>
<br>
UV-5R style radio development for CHIRP has been quited active over<br>
the last 4+ years. Except for a few recent models that chose not to<br>
provide their firmware version, it you cannot program your UV-5R<br>
variant, there is a 99% chance that it is a cabling problem (device<br>
driver and/or connection of the cable to the radio).<br>
<br>
Jim KC9HI<br>
_______________________________________________<br>
chirp_users mailing list<br>
<a href="mailto:chirp_users@intrepid.danplanet.com">chirp_users@intrepid.danplanet.com</a><br>
<a href="http://intrepid.danplanet.com/mailman/listinfo/chirp_users" rel="noreferrer" target="_blank">http://intrepid.danplanet.com/mailman/listinfo/chirp_users</a><br>
This message was sent to Rick Frazier at <a href="mailto:ricknbrook@gmail.com">ricknbrook@gmail.com</a><br>
To unsubscribe, send an email to <a href="mailto:chirp_users-unsubscribe@intrepid.danplanet.com">chirp_users-unsubscribe@intrepid.danplanet.com</a><br>
</blockquote></div>