<div dir="ltr"><div class="gmail_extra"><div class="gmail_quote">On Sun, Dec 8, 2013 at 3:43 AM, ddubois <span dir="ltr"><<a href="mailto:woody2@questiongravity.com" target="_blank">woody2@questiongravity.com</a>></span> wrote:<br>
<blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><br>
Here's what I'm stuck on. I took an image off the Baofeng to use as a<br>
template. I'm trying to enter the RX freq of 156.2025 into the first<br>
memory channel. When I do so, I get the error "Tuning step 2.50 not<br>
supported...Frequency requires 2.50kHz step." I need to configure the<br>
channel to receive on 159.000, figured I'd set Duplex to Split and set<br>
Offset to 159.000. I'll spare you all the work-arounds I've tried, and<br>
the other errors I've seen, 'cause I'm starting to wonder if my radio<br>
won't support this "step", and I'm left to wonder what the heck "Tune<br>
step" and "channelize" are anyway? I've looked in the wiki, and done<br>
some web searching, but so far no joy. Any light would be much appreciated!<br>
<br>
Thanks much,<br>
Doug, Kansas<br></blockquote></div><br></div><div class="gmail_extra">Doug,<br></div><div class="gmail_extra">You are going about this in exactly the right way. Just use the older CHIRP daily that I pointed out earlier to get the job done. I have submitted a patch that will restore programming the UV-B5/B6 with CHIRP to a 2.5 KHz resolution and still fix the issue the previous patch was intended to address.<br>
</div><div class="gmail_extra">Jim KC9HI<br></div></div>