<div dir="ltr"><div class="gmail_extra"><div class="gmail_quote">On Wed, Oct 9, 2013 at 11:13 PM, Tony Cratz <span dir="ltr"><<a href="mailto:cratz@hematite.com" target="_blank">cratz@hematite.com</a>></span> wrote:<br>
<blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">Hello,<br>
<br>
I just purchase a UV-5R+ and was trying to program it. I'm using<br>
the chirp-daily respository version.<br>
<br>
USB Cable: : Prolific Technology Inc. pl2303 3-2:1.0: pl2303<br>
device: /dev/ttyUSB0<br>
UV-5R+ Firmware: BFB297 (as reported via power-on)<br>
<br>
I get the typical unable to connect to radio, but when it is<br>
trying to clone I see on the HT the "Welcome...." message and<br>
then I get the timeout message.<br>
<br>
As for the cable, it does seem to be full seated. I have<br>
pressed and held the plug in to make sure and get the same<br>
results.<br>
<br>
First is there a debug mode I can turn on to capture the hand<br>
shake between the computer and the UV-5R+. I figure this would<br>
help the list.<br>
<br>
<br>
Tony<br></blockquote></div><br></div><div class="gmail_extra">I agree with Milton. I would start with the Common Error Messages Page<br><br><a href="http://www.miklor.com/uv5r/UV5R-ErrorMess.php">http://www.miklor.com/uv5r/UV5R-ErrorMess.php</a><br>
<br>Also double check the date of your daily build. It should be 20131002 (yyyymmdd) or newer<br><br><a href="http://trac.chirp.danplanet.com/chirp_daily/">http://trac.chirp.danplanet.com/chirp_daily/</a><br><br></div><div class="gmail_extra">
Jim KC9HI<br></div></div>