[chirp_users] Kenwood TH-F6a Problems

[K0LNY_Glenn]

Thank you very much.
Glenn
----- Original Message ----- 
From: "Jim Unroe" <rock.unroe at gmail.com>
To: "Discussion of CHIRP" <chirp_users at intrepid.danplanet.com>
Sent: Wednesday, August 10, 2022 3:41 PM
Subject: Re: [chirp_users] Kenwood TH-F6a Problems


On Wed, Aug 10, 2022 at 2:19 PM K0LNY_Glenn <glenn at ervin.email> wrote:
>
> Hi Jim,
> Here it is attached.
> Thanks.
>
> Glenn

Glenn,

The TH-F6A won't accept the frequencies of channels 11-24, 91-95,
97-101 & 106. They require a frequency STEP of 2.5 KHz which the radio
does not support. See FREQUENCY STEP SIZE in the User's Manual (page
37).

The radio accepts the frequencies from channels 125-300 but will not
display these channels when the A band is selected because their
frequencies are outside the ranges for the A band. They display as
expected when the B band is selected. This is consistent with the
radio's specifications according to the User's Manual (page 54).

All frequencies within the 2 meter (144-148 MHz), 1-1/4 meter (222-225
MHz) and 70 centimeter (430-450 MHz) ham bands will transmit.
Frequencies outside of those ranges have TX disabled (RX only beep is
heard).

I always leave my radio in PC mode. It only needs to be switched to
SP/MIC or TNC when you intend to use those devices.

I hope this helps.

Jim KC9HI
_______________________________________________
chirp_users mailing list
chirp_users at intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to K0LNY at glenn at ervin.email
To unsubscribe, send an email to 
chirp_users-unsubscribe at intrepid.danplanet.com
To report this email as off-topic, please email 
chirp_users-owner at intrepid.danplanet.com
Searchable archive: 
https://www.mail-archive.com/chirp_users@intrepid.danplanet.com