[chirp_users] channel mode issues

[Tall Pine Construction]

Thank you so much, i was thinking i didnt finish something right. that 
was it. it works properly now. i just need to practice and learn more on 
these things. thanks again

------ Original Message ------
From: "Jim Unroe" <rock.unroe at gmail.com>
To: "Discussion of CHIRP" <chirp_users at intrepid.danplanet.com>
Sent: 1/10/2021 9:51:26 AM
Subject: Re: [chirp_users] channel mode issues

>On Sun, Jan 10, 2021 at 10:35 AM Tall Pine Construction
><tallpineomaha at gmail.com> wrote:
>>
>>  i looked thru faqs and lists didnt find info. i have 2 Baofeng uv-82hp radios and they will not switch to channel mode. i hold down menu button and switch off/on power. powers up everytime in frequency mode. i uploaded info to radios using chirp and can download from radios.
>
>This is most likely due to you performing a RESET on one or both of
>the radios. Performing a menu 40 (RESET) on a UV-82HP switches the
>radio to VFO mode and disables the "VFO/MR Switching" setting. Don't
>ever perform a RESET on a UV-82HP unless you have a computer running
>CHIRP and a working programming cable close by.
>
>After download from the UV-82HP, CHIRP inherits this VFO/MR Setting as
>"disabled". Until you enable the setting in CHIRP, uploading the image
>into any UV-82HP radio will disable the setting preventing the radio
>from switching between VFO and MR modes.
>
>Settings -> Advanced Settings -> VFO/MR Switching (BTech UV-82HP only). [X]
>
>Jim KC9HI
>_______________________________________________
>chirp_users mailing list
>chirp_users at intrepid.danplanet.com
>http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>This message was sent to todd at tallpineomaha at gmail.com
>To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com