[chirp_users] UV5X Programming issue

White Ranger cortchubby20007 at gmail.com
Sat Aug 21 12:33:09 PDT 2021


Radio should be ON when up or downloading.
Remove the driver and cable program, reboot PC reload driver
SHOULD correct issue. If using aftermarket cable check to see contacts are
CLEAN (*shiny) and fit TIGHTLY into the mike provisioning adapter (Mic
jack) DO NOT touch ANY buttons while programming. Worst case, prior to
programming RESET the radio to factory resets then load your amended
program.

On Thu, Aug 19, 2021 at 2:03 PM Jim Unroe <rock.unroe at gmail.com> wrote:

> Hi Eric,
>
> On Thu, Aug 19, 2021 at 12:47 PM Eric Chopin <echopin27 at gmail.com> wrote:
> >
> > UV5XP....
> >     However to get CHIRP to see the radio either in the 'Download from
> radio'
> >     or 'Upload to radio' ... with the cable plugged in to my PC or my
> MAC, the
> >     radio must me switched OFF...then as I select 'Download or upload'
> as I
> >     select 'OK' i must immediately switch ON my radio then CHIRP sees it
> and
> >     proceeds. If I try to 'Download or upload' with the radio already
> switched
> >     on I get the message 'The radio did not respond' as CHIRP cannot see
> it
> >     connected.
> >     Any suggestions?
> >     Thanks
> >     VE7ECJ
>
> That sounds like a programming cable/driver issue. Also, to program
> that radio you must choose...
>
> Vendor: Radioddity
> Model: UV-5G
>
> Jim KC9HI
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to cortchubby20007 at gmail.com at
> cortchubby20007 at gmail.com
> To unsubscribe, send an email to
> chirp_users-unsubscribe at intrepid.danplanet.com
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20210821/b544e8b4/attachment.html 


More information about the chirp_users mailing list