[chirp_users] Error 5
tonyg7txu at gmail.com
Fri Oct 23 15:21:04 PDT 2020
Your problem stems from using Windows.
On Fri, 23 Oct 2020 at 23:13, Jim Unroe <rock.unroe at gmail.com> wrote:
> On Fri, Oct 23, 2020 at 4:25 PM Chris Hastie <c.hastiessho at gmail.com>
> > When I went to my device manager it gave me a com3 comport. When I click
> on the read from radio, it gives me the information of comport 3. I then
> push monitor and push transmit 3 times. after a few seconds I get the error
> 5 notice. I have a Baofeng GT-3TP. What am I doing wrong?
> Why do you "push monitor" and "push transmit"? The cloning process
> should occur without doing anything at the radio.
> The most common problem is using a programming cable with a
> counterfeit Prolific chip with Windows. If the chip is Prolific (check
> Device Manager) and you are using Windows Vista, 7, 8 or 10, you must
> download, install and select an older Prolific v184.108.40.206 device driver
> before you programming cable will work properly.
> Check this page for a link to the driver and instructions for
> selecting it after it is installed. Only install this driver if
> Windows recognizes the chip in your cable as a Prolific type chip.
> Jim KC9HI
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> This message was sent to Tony Ling at tonyg7txu at gmail.com
> To unsubscribe, send an email to
> chirp_users-unsubscribe at intrepid.danplanet.com
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the chirp_users