[chirp_users] BAOFENG UV-S9T

Chris Luppens jcluppens at ussailing.net
Tue Jun 16 18:32:33 PDT 2020


Not sure I am responding properly but found cross reference and yes UV-5RX3 worked!!  My first time at this so am learning "tricks" as I go,,, 
Thanks much!

Chris KG5BBF

--Original Message-----
From: chirp_users-bounces at intrepid.danplanet.com <chirp_users-bounces at intrepid.danplanet.com> On Behalf Of Jim Unroe
Sent: Tuesday, June 16, 2020 7:07 PM
To: Discussion of CHIRP <chirp_users at intrepid.danplanet.com>
Subject: Re: [chirp_users] BAOFENG UV-S9T

On Tue, Jun 16, 2020 at 7:24 PM Chris Luppens <jcluppens at ussailing.net> wrote:
>
> Have new radio and this specific model does not appear on the list 
> when setting up to clone the radio. I have tried every model on the 
> list and I get same result “Radio did not respond.  I  can see the USB 
> Serial Port (Com3) installed and the USB Serial Converter pops up when 
> the connector cable is installed . (I did install largest drivers.)
>
>
>
> So as the “newer” radio not listed am I just out of luck or what? I bought cable from BTECH and downloaded CHIRP from WWW.Baofengtech.com/download as instructed.
>
>
>
> Chris Luppens

The selection you should use is most likely Vendor: Radioddity and
Model: UV-5RX3. If you try this and it fails, attach a debug.log file.

Jim KC9HI
_______________________________________________
chirp_users mailing list
chirp_users at intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to John Luppens at jcluppens at ussailing.net To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com




More information about the chirp_users mailing list