[chirp_users] New to ham radios

James Walker
Fri Dec 11 14:35:18 PST 2020


This is the latest,

Error code port com4 (Error 5) Access is denied 

Respectively,

> On Dec 11, 2020, at 2:30 PM, James Walker <jwalker3311 at gmail.com> wrote:
> 
> No luck the driver stays as 10.0
> 
> 
> 
> 
>> On Dec 11, 2020, at 2:02 PM, James Walker <jwalker3311 at gmail.com> wrote:
>> 
>> All,
>> 
>> Still no luck I’ve followed the instructions, downloaded the 3.0 files to o a new folder, no luck the only thing that has changed is going from com6 to com4 
>> 
>> Respectively,
>> 
>>>>> On Dec 11, 2020, at 12:47 PM, Jim Unroe <rock.unroe at gmail.com> wrote:
>>>>> 
>>>>> On Fri, Dec 11, 2020 at 1:56 PM James Walker <jwalker3311 at gmail.com> wrote:
>>>>> 
>>>>> 
>>>>> Good morning,
>>>>> 
>>>>> I bought a set of Baofeng UV-82hp radios a few weeks ago since than I have not been able to program them. I tried two different cables so far the one that came with the radios and one that I bought from Amazon, the Amazon cable says it’s FTDI, it does flash and recognize my radios but I get an error message while trying to clone  says that the radio can’t be Recognized by com port 6. I’ve tried to update, install, reinstall the ports abound twenty times. I have no idea what I’m doing wrong. I’m going to try another cable any Sunday would be great!
>>>>> 
>>>>> Respectively,
>>> 
>>> 
>>> James,
>>> 
>>> Make sure the 2-pin plug of the programming cable is fully inserted
>>> into the socket of the UV-82HP. The metal pins can stick in the metal
>>> rings of the UV-82 series radios and make you think the plug is fully
>>> seated when it has yet a tiny bit more distance to go. I had this
>>> issue early on with my UV-82 radios but eventually "learned" to get
>>> them fully inserted the first time, every time.
>>> 
>>> Jim KC9HI
>>> _______________________________________________
>>> chirp_users mailing list
>>> chirp_users at intrepid.danplanet.com
>>> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
>>> This message was sent to James Walker at jwalker3311 at gmail.com
>>> To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com



More information about the chirp_users mailing list