[chirp_users] Chirp and BaoFeng UV 5R not communicating
cgierke at cox.net
Sun Aug 23 14:47:57 PDT 2020
no luck yet.
I tried pressure straight into the radio, to the back side of the radio, to the front side of the radio, to the top of the radio and to the bottom of the radio.
similar results, the LCD screen blinks and goes back to the beginning screen.
thanks again for the suggestion
> On August 22, 2020 at 3:50 PM Jim Unroe < rock.unroe at gmail.com mailto:rock.unroe at gmail.com > wrote:
> On Sat, Aug 22, 2020 at 6:46 PM Charles Gierke < cgierke at cox.net mailto:cgierke at cox.net > wrote:
> > > On Wednesday my 2 BaoFeng UV 5R radios could download and upload to CHIRP.
> > >
> > > On Friday all I got was the following message: Radio Did Not Respond.
> > >
> > > I tried reloading the latest version of CHIRP, no change. I tried an earlier version of CHIRP, no change. I reloaded the latest version back, no change. Visually the radio's red light blinks then the LED display blinks then the error message shows up on CHIRP.
> > > >
> > > Any suggestions?
> > >
> > > Thanks Chuck KJ7INT
> > > Hi Chuck,
> You will get the exact same error message if you don't plug the 2-pin
> plug into the radio. So make sure that the 2-pin plug is fully
> inserted into the socket of the radio. Some have had to put a little
> pressure on the plug during the cloning process.
> Jim KC9HI
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com mailto:chirp_users at intrepid.danplanet.com
> This message was sent to Chuck at cgierke at cox.net mailto:cgierke at cox.net
> To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com mailto:chirp_users-unsubscribe at intrepid.danplanet.com
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the chirp_users