[chirp_users] Rs: setting up a uv-5ra via Chirp

John La
Tue Oct 15 05:47:12 PDT 2019


Refer to the guides and examples at the bottom of 
www.Miklor.com/COM/UV_CHIRP.php

This may assist.




John   K3NXU
www.Miklor.com

 






 

From: chirp_users-bounces at intrepid.danplanet.com
[mailto:chirp_users-bounces at intrepid.danplanet.com] On Behalf Of Steve
Sent: Tuesday, October 15, 2019 3:57 AM
To: chirp_users
Subject: [chirp_users] Rs: setting up a uv-5ra via Chirp

 

Hi chirp_users. I am having trouble understanding Chirp. I have no problem
programming my  Baofeng UV-5RA HT direct from the ht's onboard keyboard. I
don't understand some of the columns on the Chirp display after uploading
the ht's memory. The memory in the ht should be clean after the factory
reset.  In the attached picture memory channels 1 to 10 are the way all of
the memory channels are after the memory up load to Chirp after the ht
factory reset. Now to the collumns,  I know the column (tone) is for the tx
ctcs and I assume that the (tonesql) is the rx ctcs. Why do the ctcs columns
have 88.5hz in both columns. Those columns should be empty or 00.0 like in
ch 11 in the attached picture. And what are the columns DTCS code,DTCS rx
code DTCS pol. Why is there numbers and letters in the DTCS columns? Cross
Mode I know, Duplex I know, offset I know, mode and power I know. Somewhere
in Chirp is the setup to program the displays MDF (A) and MDF (B).  I have
seen a lot of chats saying it is there but no direct info to find it. I
could use some help please.    

 

 

The listing of the attachments is as following:

  (1) ht at factory reset.jpg (139.7 K)

 

Steve,   <mailto:kc7byp at gmail.com> kc7byp at gmail.com

>From the desk of the radio station KC7BYP

10/14/2019 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20191015/a9c9a5da/attachment.html 


More information about the chirp_users mailing list