[chirp_users] Yaesu FTM-400

Fugawee fugawee at gmail.com
Thu Jun 13 20:07:16 PDT 2019

I loaded the Adams7 software but it will nt see the MEMFTM400D.dat file.
I copied the file from the sd card to the laptop....

I did read enough on https://chirp.danplanet.com/issues/1469
to figure out a way to use Chirp with the FTM400....
Basically someone uploaded a file (ftm400.py) and you load that into Chirp,
then you open the file and you can use radioreference or whatever to load
local repeaters,
then save the file... Takes a little time to figure how to save it as the
right file name,but not hard.
I loaded all the local 2mtr/440 repeaters and pasted them into the .dat
file,saved it and then loaded it into
the radio through the sd card.... although I only added the TOP (vfo A)
channels,it seems to be
working just fine.

Thank you for taking time to reply.


On Thu, Jun 13, 2019 at 4:44 PM Tom Henderson <Tom at henderson4.us> wrote:

> In my experience, just barely.
> Tom Henderson
> On 6/13/19 4:18 PM, Nigel A. Gunn G8IFF/W8IFF wrote:
> > Does Yaesu's programming software not work?
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to fugawee at fugawee at gmail.com
> To unsubscribe, send an email to
> chirp_users-unsubscribe at intrepid.danplanet.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20190613/e60654d7/attachment-0002.html 

More information about the chirp_users mailing list