[chirp_users] cloning cable wiring diagram
dwage at dwage.com
Sun Sep 16 21:32:27 PDT 2018
Why is this off topic?
Dennis M. Wage (W9BOQ)
245 Corum Hill Road
Castalian Springs, TN 37031
(615) 310-4242 Cell
(615) 562-5128 Home
On Sun, Sep 16, 2018 at 9:57 PM John La <Johnla at usa.net> wrote:
> Actually, this information is very much appreciated, and will be added to
> the Miklor site.
> Please email your callsign to me, Peter, so I can give you credit for the
> As this is off topic for this forum, please forward correspondence to the
> email below so we can close this thread.
> Many thanks,
> Alpha @ Miklor.com
> *From:* chirp_users-bounces at intrepid.danplanet.com [mailto:
> chirp_users-bounces at intrepid.danplanet.com] *On Behalf Of *Peter
> *Sent:* Saturday, September 15, 2018 4:18 PM
> *To:* chirp_users at intrepid.danplanet.com
> *Subject:* [chirp_users] cloning cable wiring diagram
> I recently ordered this TENQ "cloning" cable from Amazon:
> This cable has Kenwood style connectors (3.5mm TRS & 2.5mm TRS) on each
> end, for radio-to-radio configuration copy between Baofeng, Wouxun, and
> "any two-pin style radio with a Kenwood Baofeng plug".
> I wanted to verify the pinout before adding it to my radio bag. So I
> spent several hours scouring the Internet for a wiring diagram for such a
> cable, but with no success. Even simple pinout descriptions were somewhat
> vague ("back-to-back", etc.). So I ultimately buzzed out the cable with a
> DVM, tabulated the results, and mocked up a JPEG diagram based on an image
> that originally came from Miklor.com. See attached for the finished
> product. The diagram shows that the cable basically has Data Tx from one
> end connected to Data Rx on the other and vice-versa, with Data Ground
> connected between both ends.
> I wanted to submit this to John for possible inclusion on his site, but I
> don't see any contact form there. I do know that he posts to this list so
> here I am... John, if you are interested, feel free to re-post wherever
> you'd like, maybe here?
> P.S. I do understand that this list is for CHIRP issues, hence any cable
> discussion would normally be limited to "programming" cables, e.g. Kenwood
> to USB with a suitable integrated controller chip. However, I am thinking
> that this info might be useful to some folks here regardless.
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> This message was sent to Dennis Wage at dwage at dwage.com
> To unsubscribe, send an email to
> chirp_users-unsubscribe at intrepid.danplanet.com
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the chirp_users