[chirp_users] Chirp and UV50-X2

[Darby Collier]

The plug jack for programming is the 3.5mm on the front. The one on back is
for your speaker. Then you should just have to select the right comm' port
from the drop down in CHIRP.

On Wed, Jun 13, 2018, 10:21 Jean-Charles HUILLIER <jchuillier at free.fr>
wrote:

> Thanks I'll look into it, in fact the plug is on the back on the 50-X2
> but
> maybe I didnt plug it all the way.
>
> > The radio end of the cable is a tip-ring-ring-sleeve phone plug.   Just
> > in case you haven’t verified, make sure it seats very firmly in the
> data
> > jack on the radio's front panel.   I had a similar issue when the cable
> > wasn’t fully seated.   CHIRP couldn’t read the radio’s config.
> >
> > -Charley   KE4QBW
> >
> >
> > _______________________________________________
> > chirp_users mailing list
> > chirp_users at intrepid.danplanet.com
> > http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> > This message was sent to Jean-Charles HUILLIER at jchuillier at free.fr
> > To unsubscribe, send an email to
> > chirp_users-unsubscribe at intrepid.danplanet.com
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to DarbyInGreen at collier.darby at gmail.com
> To unsubscribe, send an email to
> chirp_users-unsubscribe at intrepid.danplanet.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://intrepid.danplanet.com/pipermail/chirp_users/attachments/20180613/9bbb44d6/attachment.html