[chirp_users] programming issues

[Glenn Wise]

9-20-19
Jim, Thanks.  I knew there must be something I was  missing.  
Will obtain correct cable and respond back.
73'3  Glenn Wb4zjb

-----Original Message-----
From: chirp_users-bounces at intrepid.danplanet.com [mailto:chirp_users-bounces at intrepid.danplanet.com] On Behalf Of Jim Unroe
Sent: Wednesday, September 20, 2017 5:31 AM
To: Discussion of CHIRP
Subject: Re: [chirp_users] programming issues

On Tue, Sep 19, 2017 at 11:04 PM, Glenn Wise <ruerue at windstream.net> wrote:
 9-19-2017
 I am using Chirp and a TYT USB cable to program a TYT-9000D 2 meter 
 ham radio.

 Software and USB cable work without any issues.
 I have tried MULTIPLE times to use same version of CHIRP and same USB 
 cable to program a QTY-7900D and a QTY-8900D.

 I have NOT ever been able to read the QYT radio’s.  Neither model.
 The software will appear to start to read the radio and then drop out.
 Screen shows either comm. Error or says radio would not go into clone mode.

 By the software and cable working on the TYT-9000D, in my mind that 
 clears the software and cable.

 IF there were any issues with the software or the cable, I don’t 
 believe I could use the combo on the TYT-9000D.
 I am open to any suggestions as what to do. HELP
Glenn Wb4zjb
Glenn,
The QYT radios require a different programming cable. 
The TYT uses only the ring (TXD/RXD) and sleeve (GND) connections where 
the QYT radios use the tip (TXD), ring (RXD) and sleeve (GND) connections.
Jim KC9HI


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus