[chirp_users] Can't upload to FT-60R

[Jackson Pemberton]

Exactly. It is the last step before transfer of data should begin. I had the same problem then happened to notice in the FT-60R manual  that when cloning you need to hold down the PTT switch on the sending radio for a full second. I tried that with CHIRP upload and it finally worked! I complained to the CHIRP people that the instruction dialog in the software did not say “a full second” and they fixed it in later versions. Your version should be telling you to hold it for at least a full second.

Hope this helps.

Jackson Pemberton, W7VMK

> On May 2, 2017, at 12:38 AM, John Perry <wx5jp at jpunix.net> wrote:
> 
> On 5/1/2017 10:16 PM, Jackson Pemberton wrote:
>> Be sure to hold down the “Send” button on your computer for at least a full second. See the Cloning instructions in the manual - your computer is the “source" “radio” while uploading to your ft-60R.
>> 
>> Jackson Pemberton  W7VMK
> 
> Are you talking about a "Send" button in the CHIRP application on my
> computer?
> 
> -- 
> John Perry - WX5JP
> 
> 
> _______________________________________________
> chirp_users mailing list
> chirp_users at intrepid.danplanet.com
> http://intrepid.danplanet.com/mailman/listinfo/chirp_users
> This message was sent to Jackson Pemberton at jacksonpemberton at gmail.com
> To unsubscribe, send an email to chirp_users-unsubscribe at intrepid.danplanet.com

Best regards,
Jackson Pemberton